1 items found for
Sonax Speaker Stands
VTI UF UF Series Speaker Stands
- Shopper in
San Francisco, CA
Great straight forward designed loudspeaker stands. Simple clean lines and the spikes are adjustable. All you need to supply is
a Phillips screwdriver and about 10 min to fully setup the stands. The only complaint I had was the somewhat tacky VTI emblem on the front of the stands. But a simple solution is to twist the nameplate and it will separate from the stand. A little cleaner and nobody is none the wiser it ever existed. Wire management is simple enough its a hole in the rear tube that runs out the bottom of the stand, great design but it might not work so well if you get that super thick speaker cable. I am running 10 gauge beldon 5000 w/o any problems. If your looking for a minimalist design that is sturdy and also fillable with sand/shot take a hard look at this stand.
Hide full review